Commercial Service
Rolling Steel & Coiling Doors
Coiling service doors and hurricane-rated rolling steel — for openings where a sectional won't fit and a shutter isn't tough enough.
- Cornell, Cookson, Overhead Door commercial lines
- Hurricane / wind-load rated coiling shutters
- Manual chain hoist or motor operator
- Spring re-tensioning and barrel replacement
What's included
- Slat count and barrel sizing to your opening
- New guides, brackets, and bottom bar
- Motor operator or manual chain hoist install
- Safety edge / photo eye integration
- Hood, weather seal, and mounting hardware
- Job-site cleanup and haul-away
How it works
Step 1
Measure
We measure the rough opening, existing guides, and headroom to size the coil correctly.
Step 2
Spec
Slat gauge, insulation, wind-load rating, and motor sized to your duty cycle.
Step 3
Install
New guides mounted plumb, barrel installed, motor wired, and safety devices calibrated.
Step 4
Train
We walk your team through operation, e-stop location, and manual override.
Curtains bind before they break
A rolling steel door almost never fails suddenly. It gets progressively harder to run as the curtain works against its guides, the slats pick up dirt and salt, and the barrel bearings dry out. By the time it jams the damage is done. On this coast the guides are where it starts, because salt collects in the channel and never dries out.
Storefront security shutters
For a retail unit or a restaurant, a shutter that will not close is not an inconvenience, it is a premises you cannot lock. We treat that as an emergency, secure the opening the same night wherever possible, and complete the repair around your trading hours rather than through them.
Coiling service doors on warehouses and bays
Rolling steel is what goes on an opening that has to survive traffic and does not have the headroom for a sectional. What wears is the barrel, the counterbalance spring inside it and the bottom bar. Those are rebuildable, and on a door with a sound curtain a rebuild costs a fraction of a replacement — which we will tell you rather than quoting a new door by default.
Motor operation and manual release
Most commercial rolling doors run on a gear-head or hoist operator, and every one of them needs a working manual release for when the power is out. That release is the thing nobody tests until they need it. We check it on every service visit, because a coiling door with a seized chain hoist during an outage is an opening nobody can move.
Storefront shutters on the older main streets
A large share of our rolling steel work is not industrial at all — it is the retail and restaurant blocks with original openings. Downtown Punta Gorda, Venice Avenue, Dearborn Street in Englewood, Pine Avenue on Anna Maria and the older Main Street frontages in Sarasota all have shutters fitted into masonry that predates the current guide standards. Parts are rarely off the shelf on those. We measure the curtain and the guides rather than assuming a catalogue match, because on a storefront a wrong part means a unit that cannot lock overnight.
Facilities we service
Frequently asked questions
Do you service Cornell and Cookson doors?+
Yes. We stock the common springs, brackets, and slat sections for Cornell, Cookson, and Overhead Door commercial coiling doors.
Can a coiling door be re-tensioned instead of replaced?+
If the barrel and slats are structurally sound, re-tensioning the spring and replacing worn brackets is usually a fraction of the cost of a new door.
Are rolling steel doors hurricane-rated?+
We install Florida Product Approved wind-load-rated coiling doors that meet Charlotte, Sarasota, Manatee, and DeSoto county code.
Other commercial services
Commercial Sectional Doors
Insulated and non-insulated commercial sectional overhead doors — sales, install, and swap-outs for warehouses, showrooms, and mixed-use bays.
See detailsHigh-Cycle Springs & Bearings
Torsion spring, cable, and bearing rebuilds sized for 25k/50k/100k cycle service — for facilities that can't afford a spring break.
See detailsCommercial Operators & Openers
Jackshaft, trolley, gear-head, and hoist operators — properly sized for commercial doors so the motor outlives the door.
See detailsCommercial Gates & Gate Operators
Slide gates, swing gates, cantilever gates, and gate operators for perimeter security. Install, repair, access control integration, and UL-325 compliance.
See detailsOn the Job
Rolling Steel Doors, on real sites.
Our own photographs from jobs of this type. Call dispatch and we will tell you what your opening needs.